Integra DTR-4.6 Zone 2—Continued, Powered Zone 2 Setting, Zone 2 Out Setting, Setup closes

DTR-4.6.book Page 67 Thursday, September 22, 2005 1:45 PM

Zone 2—Continued

Powered Zone 2 Setting

If you’ve connected your Zone 2 speakers to this AV receiver, as explained in “Using Only Speakers in Zone 2” on page 66, you must set the Powered Zone 2 setting to Act (Activated) as explained here.

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.
	The main menu appears onscreen.
2	Use the Up and Down [ ]/[ ]

buttons to select “8. Hardware Setup,” and then press [Enter]. The Hardware Setup menu appears.

3	Use the Up and Down [ ]/[ ]
	buttons to select “Powered
	Zone2,” and use the Left and
	Right [ ]/[ ] buttons to select:
	8.Hardware Setup
	------------------------
	a.PoweredZone2:NotAct
	b.Zone2 Out :Fixed
	c.Remote ID	:1

Not Act: ZONE 2 SPEAKERS termi- nals not activated.

Act: ZONE 2 SPEAKERS terminals activated.

When Act is selected and Zone 2 is turned on, the speakers connected to the ZONE 2 SPEAKERS terminals will output sound. When Zone 2 is turned off, even if Act is selected, the surround speakers will work as normal.

4	Press the [Setup] button.
	Setup closes.

Zone 2 Out Setting

If you’ve connected your Zone 2 speakers to a power amp with no volume control in Zone 2, as explained in “Using Another Amp in Zone 2” on page 66, you must set the Zone 2 Out setting to Variable.

When set to Variable, the ZONE 2 OUT L/R jacks work like pre outs.

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.
	The main menu appears onscreen.
2	Use the Up and Down [ ]/[ ]

buttons to select “8. Hardware Setup,” and then press [Enter]. The Hardware Setup menu appears.

3	Use the Up and Down [ ]/[		]
	buttons to select “Zone 2 Out,”
	and use the Left and Right [		]/
	[ ] buttons to select:
	8.Hardware Setup
	------------------------
	a.PoweredZone2:NotAct
	b.Zone2 Out :Fixed
	c.Remote ID	:1

Fixed: The ZONE 2 OUT L/R jacks work as line outs, and the volume for Zone 2 is set on the receiver or inte- grated amp in Zone 2.

Variable: The ZONE 2 OUT L/R jacks work as pre outs, and the volume for Zone 2 is set on this AV receiver.

4	Press the [Setup] button.
	Setup closes.

Note:

•These settings can also be changed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

67