Integra DTR-4.6 instruction manual 1, 2 1, Changing the Input Display, First Time Setup-Continued

DTR-4.6.book Page 41 Thursday, September 22, 2005 1:45 PM

First Time Setup—Continued

Changing the Input Display

If you connect an -capable Integra MiniDisc recorder, CD recorder, or next generation HDD-compat- ible component to the TAPE IN/OUT or VIDEO 3 IN

jacks, for to work properly, you must change this setting.

This setting can only be changed on the AV receiver.

1, 2 1, 2

1	Press the [Tape] or [Video 3]
	input selector button so that
	“TAPE” or “VIDEO3” appears on
	the display.
	or

2	Press and hold down the [Tape]
	or [Video 3] input selector button
	(about 3 seconds) to change the
	setting.
	Repeat this step to select MD, CDR, or
or	HDD.
	For the Tape input selector, the setting
	changes in this order:
	→ TAPE → MD → CDR → HDD

For the Video 3 input selector, the set- ting changes in this order:

VIDEO 3 ↔ HDD

Note:

HDD can be selected for the Tape input selector or

Video 3 input selector, but not both at the same time.

41