Integra DTR-7 instruction manual Using Multi-RoomRemote System, Outline of Multi-roomRemote System

Using Multi-Room Remote System

Outline of Multi-room Remote System

If you connect Onkyo Multi-room Remote System components as shown in the figure below, you can control the components from a sub- room as well as from the room where the DTR-7/DTR-6 is located. The Multi-Room Remote System allows remote operation when the A/V system is mounted in a cabinet or rack.

The following equipment (sold separately) is essential for using the Onkyo Multi-Room System:

•Onkyo's Multi-Room System kits HKT-600 or HKT-700 (IR Remote Controller Extension System), or

•Multiroom A/V distribution and control systems from Niles® and Xantech® to name a few

Make connection as shown below. Do not plug the equipment into the power source until the connection is complete.

Enjoying Music and Movies in the Sub-room

DTR-7/DTR-6

Connection		R	L	R	L	V	S	SURROUND SPEAKERS		FRONT SPEAKERS A
example of Onkyo	DIGITAL INPUT
	COAXIAL	AMP IN
		FRONT					OUT
Multi-room System	1	PRE OUT				VIDEO-1	ANTENNA
								R	L	R	L
	COAXIAL2	SUB					AM
		FRONT					IN
kit HKT-600	OPTICAL	WOOFER					OUT			CENTER
	1	CENTER				VIDEO-2				SPEAKER
							IN			CAUTION: SPEAKER IMPEDANCE
	OPTICAL	SURROUND					FM	R	L	6 OHMS MIN. / SPEAKER
	2						75
						VIDEO-3

FRONT			IN
OPTICAL
SUB			DVD		AC OUTLETS
WOOFER				FRONT SPEAKERS B	AC 120V 60Hz
DIGITAL OUTPUT			IN
			AV RECEIVER		SWITCHED
CENTER					TOTAL 120W 1A MAX.
SURROUND		(REC)	MODEL NO. DTR-7
MULTI CHANNEL			MONITOR
INPUT		OUT	OUT
R	L	TAPE	�		AC INLET
			SOURCE
CD		IN	MULTIOUT
		(PLAY)
GND			VIDEO
PHONO			S VIDEO
			OSD SELECTOR

R	L	R	L
			LOCAL REMOTE	REMOTE

CONTROL

�MULTI SOURCE OUT

R L DTR-7 only

LOCAL REMOTE

speaker	3		speaker
	TV
L			R
2			2
S-Video
conection
cable
	Video connection cable
	-	L	+
	L	R
	-		+
	R

Audio connction cable

Mini Plug cable

:Signal flow

Main room

4

1

Power

HB-100supply Connecting block

120V AC (unswitched)

Additional Amplifier
5
Remote sensor HR-600	Remote contoroller
Sub room

1.Connect the receiver to the power amplifier.

2.Connect the sub-room speaker cables to the speaker terminals on the power amplifier.

3.Connect the receiver to the TV.(DTR-7 only)

4.Install the Connecting block in the main room, then connect it to the REMOTE jack on the receiver.

5.Install the remote sensor in the sub-room, then connect it to the connecting block in the main room.

46