Intel 1000SX manual Stand-alone Mode, Cabling for a single switch

CH A P T E R 3 Cable the module

Stand-alone Mode

Cabling for a single switch

Follow these instructions to provide a high-speed (1000Base-SX) link between the switch containing the 1000SX Advanced Module and an- other switch, device or group of switches:

Warning When used in stand-alone mode, this module must not be installed in a switch containing a Stack Interface Module, a Matrix Module or a 1000Base Module set in stack mode.

1Plug the SC connectors on the optic fiber cable into the RX and TX sockets on the 1000Base-SX connector.

1000SX Advanced Module for 500 Series Switches

CLASS 1 LASER PRODUCT

1000Base-SX Stack Interface Module

5004

2Plug the other end of the cable into a device and check the LEDs on the 1000SX Advanced Module to verify the link. For informa- tion on the LEDs, see Chapter 2.

12