Intel manual Intel Confidential, Data Mode AT COMMANDS, 1, 0, 536EX Chipset Developer’s Manual

Data Mode AT COMMANDS

Table 18. Data Mode Command Descriptions (Continued)

Command	Default		Description
		Break Handling: Controls break handling in error control operation. It accepts three numeric
		subparameters:
		Syntax:
		+EB = <break selection>, <timed>, <default length>
		<break selection> specifies the type of break to be signaled to the remote DCE upon detecting one from
		the local DTE.
		0	Ignore Break (do not signal to remote DCE)
		1	Non-expedited, non-destructive
		2	Expedited, non-destructive
+EB	1, 0, 30	3	Expedited and destructive
		<timed> specifies if the break signal to be signaled to the remote DCE is timed or not.
		0	Sent without a break signal length
		1	Sent with break signal length
		<default length> specifies the amount of time in tens of milliseconds that a break should be signaled to
		the local DTE when an indication of a break is received from the remote DCE without explicitly indicated.
		0	Do not deliver received break to DTE
		1	Default break length 0.01 to 2.54 seconds. Used for default to signal DTE when break
			received from the remote DCE without break length
		Controls the use of breaks in V.42.

NOTE: An asterisk (*) denotes the factory-default setting.

48 536EX Chipset Developer’s Manual

Intel Confidential