![](/images/new-backgrounds/1112420/11242053x1.webp)
![](/images/new-backgrounds/1112420/11242053xi2.webp)
![](/images/new-backgrounds/1112420/11242053xi3.webp)
![](/images/new-backgrounds/1112420/11242053xi4.webp)
![](/images/new-backgrounds/1112420/11242053xi5.webp)
![](/images/new-backgrounds/1112420/11242053xi6.webp)
![](/images/new-backgrounds/1112420/11242053xi7.webp)
![](/images/new-backgrounds/1112420/11242053xi8.webp)
![](/images/new-backgrounds/1112420/11242053xi9.webp)
![](/images/new-backgrounds/1112420/11242053xi10.webp)
![](/images/new-backgrounds/1112420/11242053xi11.webp)
![](/images/new-backgrounds/1112420/11242053xi12.webp)
![](/images/new-backgrounds/1112420/11242053xi13.webp)
![](/images/new-backgrounds/1112420/11242053xi14.webp)
![](/images/new-backgrounds/1112420/11242053xi15.webp)
![](/images/new-backgrounds/1112420/11242053xi16.webp)
![](/images/new-backgrounds/1112420/11242053xi17.webp)
![](/images/new-backgrounds/1112420/11242053xi18.webp)
![](/images/new-backgrounds/1112420/11242053xi19.webp)
![](/images/new-backgrounds/1112420/11242053xi20.webp)
![](/images/new-backgrounds/1112420/11242053xi21.webp)
![](/images/new-backgrounds/1112420/11242053xi22.webp)
![](/images/new-backgrounds/1112420/11242053xi23.webp)
![](/images/new-backgrounds/1112420/11242053xi24.webp)
![](/images/new-backgrounds/1112420/11242053xi25.webp)
![](/images/new-backgrounds/1112420/11242053xi26.webp)
![](/images/new-backgrounds/1112420/11242053xi27.webp)
![](/images/new-backgrounds/1112420/11242053xi28.webp)
![](/images/new-backgrounds/1112420/11242053xi29.webp)
![](/images/new-backgrounds/1112420/11242053xi30.webp)
![](/images/new-backgrounds/1112420/11242053xi31.webp)
![](/images/new-backgrounds/1112420/11242053xi32.webp)
![](/images/new-backgrounds/1112420/11242053xi33.webp)
Hardware Installation
1.The system board comes with the retention module base already installed.
Retention Retention
hole hole
Retention | Retention |
hole | hole |
Retention
module base
2.Position the fan / heat sink and retention mechanism assembly on the CPU, then align and snap the retention legs’ hooks to the retention holes at the 4 corners of the retention module base.
Note:
You will not be able to snap the hooks into the holes if the fan / heat sink and retention mechanism assembly did not fit properly onto the CPU and retention module base.
Fan / heat sink and retention mechanism assembly
Unsnapped
Snapped
2
27