Intel II Installing Server Board Clips and Bumpers, Rubber Bumper and Standoff Clip Placement

Installing Server Board Clips and Bumpers

To support the server board in the Astor II chassis, you must install three rubber bumpers and eleven or twelve standoff clips (depending on the server board you are installing).

1.Peel the adhesive backing from three rubber bumpers; stick the bumpers to the chassis wall (see Figure 9, A).

2.￿Install eleven or twelve standoff clips in the chassis wall (see Figure 9, B). Gently pinch the open end of each clip with needle-nosed pliers, insert into a slot on the chassis wall, and release. Pressure holds the clip in place.

	B
	A
4.5"
	7.75"
6.0"	10.0"
	3.0"
	OM07019

Figure 9. Rubber Bumper and Standoff Clip Placement

B.Rubber bumper

C.￿Standoff clip location

Working Inside the System 21