Installing the IDE Drive Bay

1.Observe the safety and ESD precautions at the beginning of this chapter.

2.Place the drive bay into the chassis so its hinges are in their slots.

3.Move the drive bay down until the screw holes in the bay and the chassis line up.

4.￿Replace the two screws on the top of the bay (see Figure 17, C).

A

C

B

OM07560

Figure 17. Disconnect Cables and Remove Screws

A.Power cable

B.Data cable

C.￿Screws

5.Replace the screw in the flange at the bottom of the drive bay (see Figure 8, A, on page 20).

6.￿Connect data and power cables to any drives in the bay.

Working Inside the System

29

Page 29
Image 29
Intel II manual Installing the IDE Drive Bay, Disconnect Cables and Remove Screws