D
B
EA
C
OM07036
Figure 20. Installing a Removable Media Device
A.Removable media device
B.Drive rail
C.Rail tab
D.Power cable
E.Typical SCSI signal cable
Removing a 5.25-inch Peripheral Device
1.Observe the safety and ESD precautions at the beginning of this chapter.
2.Disconnect the power and signal cables from the drive.
3.The drive has two protruding plastic, snap in rails attached. Squeeze the rail tabs toward each other as you carefully slide the drive forward out of the bay, and place it on an antistatic surface.
4.Remove and save the four screws and two slide rails.
5.If you leave the bay empty, install a stainless steel EMI shield on the bay and a filler panel on the front cover for proper cooling and airflow.
6.If you do not replace the device with another SCSI device, and it was installed at the end of the SCSI signal cable, modify the cable and termination arrangement so that a proper termination exists at the end of the cable (it can be a termination device only, not necessarily a SCSI peripheral).
32 | Intel Astor II Server Chassis Subassembly Product Guide |
