Removing a Hot-swap Bay Fan

A

OM07042

Figure 26. Removing the Hot-swap Bay Fan Bracket

1.Observe the safety and ESD precautions at the beginning this chapter.

2.Remove the side cover.

3.Disconnect the fan’s power cable from the SCSI backplane.

4.￿Snap the fan out of the plastic shroud.

Installing a Hot-swap Bay Fan

1.Position the fan, label side facing away from the hot-swap bay, and snap it into the shroud.

2.Connect the fan’s power cable to the SCSI backplane (a fan in the bottom of the shroud connects to the Fan 1 header; a fan in the top of the shroud connects to Fan 0 header).

3.￿Reinstall the side cover.

Working Inside the System

41

Page 41
Image 41
Intel II manual Removing a Hot-swap Bay Fan, Installing a Hot-swap Bay Fan