Intel II manual Installing the Diskette Drive, Removing the Diskette Drive

Installing the Diskette Drive

1.Observe the safety and ESD precautions at the beginning of this chapter.

2.Remove the new 3.5-inch diskette drive from its protective wrapper, and place it component side up on an antistatic surface. Record the drive model and serial numbers in your equipment log.

3.Set any jumpers or switches according to the drive manufacturer’s instructions.

4.Slide the drive into the chassis.

5.Secure the drive to the 5.25-inch bay with the screws you removed earlier; tighten the screws firmly.

6.￿Connect the signal and power cables to the drive.

B

A

C

OM07052

Figure 14. Installing the Diskette Drive

A.Power cable

B.Signal cable

C.￿Chassis screws

Removing the Diskette Drive

1.Observe the safety and ESD precautions at the beginning of this chapter.

2.Remove the side cover.

3.Remove the front cover.

4.Disconnect the power cable and signal cable from the diskette drive.

5.Remove and save the screws that secure the diskette drive to the 5.25-inch drive bay.

6.￿Slide the drive forward and out of the system and place it component side up on an antistatic surface. If not reinstalling the same drive, place it in an antistatic protective wrapper.

26 Intel Astor II Server Chassis Subassembly Product Guide