Intel J2 650 system manual The program will launch, then select the Tools tab, System Manual Draft

After the system has rebooted touch should be working but will need to be calibrated. Click Start, All Programs, Touchkit, then Configure Utility.

The program will launch, then select the Tools tab.

Click on “4 Points Calibration” and the calibration screen will fill the screen. Use a touch screen stylus or your finger to touch each point till you hear a beep. After the fourth point is touched the calibration is complete. You can use “Draw Test” to test the calibration.

Normally the touch screen only needs to be calibrated once after the driver is loaded. Only a 4 point calibration is needed. Linearization is not required with this touch screen.

650 System Manual (Draft)	52
Version 0.4 August 20, 2008