Intel J2 650 system manual 650 UPS, Specifications, Hardware, Picture to be added here

650 UPS

Specifications

Batteries Run Time	2 Hours for the standard 650. Run time will vary
	depending on the processor used and application load
Power In	19 Volts DC
Power Out	13-16.8 Volts DC, 7.2 amps maximum
Data Interface	RS232 DB9 connector
Batteries Type	2 – 4 18650 cell Li-Ion pack with protection circuit
Battery Life	300 full discharge cycles
Charge Time	3 hours
Charger Type	Smart Microcontroller based
Software	XP Standard Generic UPS driver / J2 Smart UPS driver
Size	6” x 3.1” x 1.7” (152mm x 79mm x 43mm)

Hardware

To install and use the J2 UPS module:

1:Remove the power supply adapter form the base of the unit.

2:Install the UPS module where the power supply was mounted.

3:Connect the power output jack of the UPS to the power in jack of the unit.

4:Connect the Serial cable of the UPS to the serial port you wish to use. *

5:Connect the power supply adapter to the UPS power in jack.

6:Connect the power supply adapter to the mains power. **

7:Configure the Windows UPS drive as shown.

Picture to be added here

*The serial port connection is not needed for Windows CE.

**The mains power should be applied for 3 hours to fully charge the batteries. The unit may be running during this time but will take longer to charge.

650 System Manual (Draft)	72
Version 0.4 August 20, 2008