Intel PPC-7508F M1 user manual Super IO Device

Chapter 4 Award BIOS Setup

SUPER IO DEVICE:

The options for these items are found in its sub menu. By pressing the <ENTER> key, you are prompt to enter the sub menu of the detailed options as shown below:

Phoenix – Award CMOS Setup Utility

SuperIO Device

Onboard FDC Controller	[Enabled]		Item Help
Onboard Serial Port 1	[3F8/IRQ4]
Onboard Serial Port 2	[2F8/IRQ3]
Onboard Parallel Port	[378/IRQ7]		Menu Level ►
Parallel Port Mode	[SPP]
ECP Mode Use DMA	[3]
↑↓→←:Move Enter: Select	+/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values	F6:Fail-Safe Defaults	F7:Optimized Defaults

Descriptions on each item above are as follows:

1.Onboard FDC Controller

Select Enabled if the system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install and-in FDC or the system has no floppy drive, select Disabled.

2.Onboard Serial Port 1/2

Select an address and corresponding interrupt for the first and second serial ports.

3.Onboard Parallel Port

This item allows you to determine access onboard parallel port controller with which I/O address.

4.Parallel Port Mode

Select an operating mode for the onboard parallel (printer) port. Select Normal, Compatible, or SPP unless you are certain your hardware and software both support one of the other available modes.

5.ECP Mode Use DMA

Select a DMA channel for the parallel port for use during ECP mode.

Page: 4-16 PPC-7508F USER′S MANUAL