WIRELESS NETWORK IP CAMERA User’s Guide

Manual configuration can be done using the IP installer or the information on this page.

(If you have trouble configuring network system information, please ask your Network Administrator for assistance.)

To set DHCP, you may select ‘using DHCP’.

When selecting “using DHCP”, the IP Address, Subnet Mask Address and Gateway Address may not be activated. Under DHCP selection, the IP address may be sent to an e-mail address whenever IP address is changed. Users in a local area network may check the IP address through IP installer.

NOTE

If you select “DHCP”, you may see the rebooting message “Now the Network Camera is rebooting to apply the changes...” on the Web Browser. After completing rebooting, the Operating Status LED blinks once per second to verify that the changes were applied.

To select DHCP, you must have DHCP server in the network. Otherwise, the IP address will reboot automatically as the previous IP address. It may take 4 minutes for booting.

After rebooting, please reenter the previous IP address.

You may see the fail message from the Network Configuration page.

2.Send IP Address to E-mail

To send camera system information (Camera Name, Camera Location, DHCP IP address), check the text box and enter you e-mail address. (You should configure your SMTP server information first)

3.Server Port Number

Set the Port Number for the web server. (The default port number is ‘80’ and users can select from 80 to 1023)

4.Image Transfer Port Number

Set the port number for the image transfer. (The default port number is “8080” and users can select from 8000 to 65535)

5.Ugrade Port Number

Set the Port Number for upgrading firmware. (The default port number is “9000” and users can select from 8000~65535)

36