Model 3600 & Model 3600XL Model
Owner’s Operator and Maintenance Manual
Side Entry Whirlpool Tub
DEALER This manual MUST be given to the user of the tub
For further information on this product, please call the following
ACCESSORIES WARNING
Customer Service ‐ 1‐800‐668‐2337 Technical Support ‐ 1‐800‐668‐2337
FEATURES
TABLE OF CONTENTS
TABLE OF CONTENTS
SECTION 2-PARTS AND INSTALLATION
Removing Soap Film and Hard Water Deposits
TABLE OF CONTENTS
TABLE OF CONTENTS
Removing Calcium Deposits, Scale and Lime Build-up
SPECIAL NOTES
Disinfecting Cabinet Door
LABEL LOCATION
LABEL LOCATION
Labels located inside the Disinfecting
MODEL
TYPICAL PRODUCT PARAMETERS
TYPICAL PRODUCT PARAMETERS
3650
Models 3600 and 3600XL
FEATURES
FEATURES
Aerator Valve
Model
FEATURES
Control Panel See Above
SECTION 1-GENERAL GUIDELINES
SAVE THESE INSTRUCTIONS Important Safety Instructions
Installation
DANGER
DANGER
Electrical
Plumbing
Grounding
Maintenance and Inspection DANGER
Disinfecting
DANGER
Operation
NOTE For this procedure, refer to FIGURE 2.1 on page
SECTION 2-PARTS AND INSTALLATION
About Installation
Parts Information
Service Access Panel
FIGURE 2.1 Preparing the Work Area
SECTION 2-PARTS AND INSTALLATION
Service Access Panel
NOTE For this procedure, refer to FIGURE
Securing Tub
Electrical and Plumbing Hook-up Locations on the Tub
Electrical Installation
NOTE For this procedure, refer to FIGURE 2.3 on page
DANGER
1. Ensure a 15 AMP GFCI breaker is installed to protect the unit
NOTE For this procedure, refer to FIGURE 2.4 on page
NOTE Use 15 AMP GFCI breaker only
Service
FIGURE 2.4 Electrical Installation
SECTION 2-PARTS AND INSTALLATION
Air Switch Line Motor Cover
DANGER
Plumbing Installation
NOTE For this procedure, refer to FIGURE 2.5 on page
Post Installation Checklist
SECTION 3-OPERATING INSTRUCTIONS
Overview
SECTION 3-OPERATING INSTRUCTIONS
Disinfecting the Tub Using the Closed Loop System
FIGURE 3.1 Disinfecting the Tub Using the Closed Loop System
Opening the Tub Door
NOTE For this procedure, refer to FIGURE 3.2 on page
Opening/Closing the Tub Door
Closing the Tub Door
NOTE For this procedure, refer to FIGURE
Water Temperature Setting
Tub Operation
Operating Shower/Massage Wand
NOTE Refer to following chart for shower head adjustment settings
NOTE For this procedure, refer to FIGURE 3.5 on page
Filling Tub
NOTE For this procedure, refer to FIGURE 3.6 on page
Hydromassage
Initially
SECTION 4-SAFETY INSPECTION/ TROUBLESHOOTING
Safety Inspection Checklists
Before Each Use
Cleaning Your Tub
Cleaning
Cleaning the Door Seal Gasket
Removing Soap Film and Hard Water Deposits
Heavy Duty Cleaning Procedure
SECTION 4-SAFETY INSPECTION/TROUBLESHOOTING
NOTE Equipment needed Bucket or Pail, at least 1 Gallon
NOTE For this procedure, refer to FIGURE 4.1 on page
Calibrating the Disinfectant Flow Meter
Graduated plastic bottle, at least 16 ounces Felt Tip Pen
NOTE Liquid will be heard filling the interior plumbing of the tub
12. Close the whirlpool inlet by pulling the inlet plug out
Disinfectant Valve Injector Screw
Troubleshooting
Burp Fitting Burp Fitting
Disinfectant Cabinet Door
TYPE OF MAINTENANCE PERFORMED
Maintenance Record
MAINTENANCE PERSON
DATE
Side Entry Whirlpool Tub
LIMITED WARRANTY
Canada