Owner’s Operator and Maintenance Manual
Side Entry Whirlpool Tub
Model 3600 & Model 3600XL Model
DEALER This manual MUST be given to the user of the tub
Customer Service ‐ 1‐800‐668‐2337 Technical Support ‐ 1‐800‐668‐2337
ACCESSORIES WARNING
For further information on this product, please call the following
TABLE OF CONTENTS
TABLE OF CONTENTS
FEATURES
SECTION 2-PARTS AND INSTALLATION
TABLE OF CONTENTS
TABLE OF CONTENTS
Removing Soap Film and Hard Water Deposits
Removing Calcium Deposits, Scale and Lime Build-up
SPECIAL NOTES
LABEL LOCATION
LABEL LOCATION
Disinfecting Cabinet Door
Labels located inside the Disinfecting
TYPICAL PRODUCT PARAMETERS
TYPICAL PRODUCT PARAMETERS
MODEL
3650
FEATURES
FEATURES
Models 3600 and 3600XL
Model
FEATURES
Aerator Valve
Control Panel See Above
SAVE THESE INSTRUCTIONS Important Safety Instructions
Installation
SECTION 1-GENERAL GUIDELINES
DANGER
Electrical
Plumbing
DANGER
Grounding
Maintenance and Inspection DANGER
Disinfecting
DANGER
Operation
SECTION 2-PARTS AND INSTALLATION
About Installation
NOTE For this procedure, refer to FIGURE 2.1 on page
Parts Information
FIGURE 2.1 Preparing the Work Area
SECTION 2-PARTS AND INSTALLATION
Service Access Panel
Service Access Panel
NOTE For this procedure, refer to FIGURE
Securing Tub
Electrical Installation
NOTE For this procedure, refer to FIGURE 2.3 on page
Electrical and Plumbing Hook-up Locations on the Tub
DANGER
NOTE Use 15 AMP GFCI breaker only
NOTE For this procedure, refer to FIGURE 2.4 on page
1. Ensure a 15 AMP GFCI breaker is installed to protect the unit
FIGURE 2.4 Electrical Installation
SECTION 2-PARTS AND INSTALLATION
Service
Air Switch Line Motor Cover
NOTE For this procedure, refer to FIGURE 2.5 on page
Plumbing Installation
DANGER
Post Installation Checklist
SECTION 3-OPERATING INSTRUCTIONS
Overview
FIGURE 3.1 Disinfecting the Tub Using the Closed Loop System
Disinfecting the Tub Using the Closed Loop System
SECTION 3-OPERATING INSTRUCTIONS
NOTE For this procedure, refer to FIGURE 3.2 on page
Opening/Closing the Tub Door
Opening the Tub Door
Closing the Tub Door
Tub Operation
Water Temperature Setting
NOTE For this procedure, refer to FIGURE
NOTE Refer to following chart for shower head adjustment settings
NOTE For this procedure, refer to FIGURE 3.5 on page
Operating Shower/Massage Wand
Filling Tub
NOTE For this procedure, refer to FIGURE 3.6 on page
Hydromassage
SECTION 4-SAFETY INSPECTION/ TROUBLESHOOTING
Safety Inspection Checklists
Initially
Before Each Use
Cleaning
Cleaning the Door Seal Gasket
Cleaning Your Tub
Removing Soap Film and Hard Water Deposits
Heavy Duty Cleaning Procedure
SECTION 4-SAFETY INSPECTION/TROUBLESHOOTING
NOTE For this procedure, refer to FIGURE 4.1 on page
Calibrating the Disinfectant Flow Meter
NOTE Equipment needed Bucket or Pail, at least 1 Gallon
Graduated plastic bottle, at least 16 ounces Felt Tip Pen
NOTE Liquid will be heard filling the interior plumbing of the tub
12. Close the whirlpool inlet by pulling the inlet plug out
Troubleshooting
Burp Fitting Burp Fitting
Disinfectant Valve Injector Screw
Disinfectant Cabinet Door
Maintenance Record
MAINTENANCE PERSON
TYPE OF MAINTENANCE PERFORMED
DATE
Side Entry Whirlpool Tub
LIMITED WARRANTY
Canada