SECTION
Operating Shower/Massage Wand
NOTE: For this procedure, refer to FIGURE 3.4.
NOTE: STEPS 1 ‐ 3 are to be performed while holding the shower/massage wand over the tub.
1.Turn shower/massage wand on to desired flow by rotating shower On/Off valve (Detail “A”).
2.Adjust water temperature using the water temperature valve while watching the flow water thermometer (Detail “B”).
3.Adjust shower spray by rotating shower wand head (Detail “C”).
NOTE: Refer to following chart for shower head adjustment settings.
Stream
Shower Spray
Mixture of Spray and Pulse Massage
Pulse Massage
4. Turn shower On/Off valve to off position when finished.
DETAIL “A” | DETAIL “B” | DETAIL “C” |
| Flow Water |
|
| Thermometer |
|
|
| Shower/Massage |
|
| Wand |
| Water Temperature Valve | Head |
Shower On/Off Valve |
| |
|
|
FIGURE 3.4 Operating Shower/Massage Wand
Filling Tub
NOTE: For this procedure, refer to FIGURE 3.5 on page 27.
1.Close the drain (Detail “A”).
2.Turn tub fill On/Off valve to on position by rotating valve (Detail “B”).
3.Adjust water temperature using the water temperature valve while watching flow water thermometer (Detail “C”).
CAUTION
Before starting hydromassage, water level MUST be completely above whirlpool jets otherwise severe damage to the motor/pump will result.
4. Turn tub fill On/Off valve to off position when water reaches desired level (Detail “B”).
Side Entry Whirlpool Tub | 26 | Part No 1118387 |