Invacare 3650 manual Hydromassage, NOTE For this procedure, refer to .6 on page

SECTION 3—OPERATING INSTRUCTIONS

DETAIL “A”	DETAIL “B”
Models 3600 and 3600XL	Model 3650

Tub Fill On/Off Valve

DrainDrain

FIGURE 3.5 Filling Tub

DETAIL “C”

Flow Water Thermometer

Water Temperature

Valve

Hydromassage

CAUTION

Before starting hydromassage, water level MUST be completely above whirlpool jets otherwise severe damage to the motor/pump will result.

NOTE: For this procedure, refer to FIGURE 3.6 on page 27.

1.Close the aerator by rotating the aerator valve two turns clockwise.

2.Open the whirlpool inlet by pushing the inlet plug in.

3.Open all whirlpool jets by pulling the center of the whirlpool jet out or rotating the center counterclockwise (Detail “A”).

4.Fill the tub. Refer to Filling Tub on page 26.

5.After water level covers whirlpool jets and after bathing the resident, add Invacare Defoamer to bath water. Refer to Defoamer bottle for directions.

6.Push whirlpool On/Off (Detail “B”) button to start whirlpool jets.

7.Adjust the whirlpool aerator for desired water agitation by rotating the whirlpool aerator (Detail “C”).

8.After use, push whirlpool On/Off button (Detail “B”) to stop whirlpool jets.

9. Drain tub.

	DETAIL “A”
	Whirlpool Jet
Turn Clockwise	Push In To
to Close	Close
	Plug

DETAIL “B”

Whirlpool On/Off

Button

DETAIL “C”

Whirlpool Aerator

FIGURE 3.6 Hydromassage

Part No 1118387 27 Side Entry Whirlpool Tub