Side Entry Whirlpool Tub
Owner’s Operator and Maintenance Manual
Model 3600 & Model 3600XL Model
DEALER This manual MUST be given to the user of the tub
ACCESSORIES WARNING
Customer Service ‐ 1‐800‐668‐2337 Technical Support ‐ 1‐800‐668‐2337
For further information on this product, please call the following
TABLE OF CONTENTS
TABLE OF CONTENTS
FEATURES
SECTION 2-PARTS AND INSTALLATION
TABLE OF CONTENTS
TABLE OF CONTENTS
Removing Soap Film and Hard Water Deposits
Removing Calcium Deposits, Scale and Lime Build-up
SPECIAL NOTES
LABEL LOCATION
LABEL LOCATION
Disinfecting Cabinet Door
Labels located inside the Disinfecting
TYPICAL PRODUCT PARAMETERS
TYPICAL PRODUCT PARAMETERS
MODEL
3650
FEATURES
FEATURES
Models 3600 and 3600XL
FEATURES
Model
Aerator Valve
Control Panel See Above
Installation
SAVE THESE INSTRUCTIONS Important Safety Instructions
SECTION 1-GENERAL GUIDELINES
DANGER
Plumbing
Electrical
DANGER
Grounding
Disinfecting
Maintenance and Inspection DANGER
Operation
DANGER
About Installation
SECTION 2-PARTS AND INSTALLATION
NOTE For this procedure, refer to FIGURE 2.1 on page
Parts Information
SECTION 2-PARTS AND INSTALLATION
FIGURE 2.1 Preparing the Work Area
Service Access Panel
Service Access Panel
Securing Tub
NOTE For this procedure, refer to FIGURE
NOTE For this procedure, refer to FIGURE 2.3 on page
Electrical Installation
Electrical and Plumbing Hook-up Locations on the Tub
DANGER
NOTE For this procedure, refer to FIGURE 2.4 on page
NOTE Use 15 AMP GFCI breaker only
1. Ensure a 15 AMP GFCI breaker is installed to protect the unit
SECTION 2-PARTS AND INSTALLATION
FIGURE 2.4 Electrical Installation
Service
Air Switch Line Motor Cover
Plumbing Installation
NOTE For this procedure, refer to FIGURE 2.5 on page
DANGER
Post Installation Checklist
Overview
SECTION 3-OPERATING INSTRUCTIONS
Disinfecting the Tub Using the Closed Loop System
FIGURE 3.1 Disinfecting the Tub Using the Closed Loop System
SECTION 3-OPERATING INSTRUCTIONS
Opening/Closing the Tub Door
NOTE For this procedure, refer to FIGURE 3.2 on page
Opening the Tub Door
Closing the Tub Door
Water Temperature Setting
Tub Operation
NOTE For this procedure, refer to FIGURE
NOTE For this procedure, refer to FIGURE 3.5 on page
NOTE Refer to following chart for shower head adjustment settings
Operating Shower/Massage Wand
Filling Tub
Hydromassage
NOTE For this procedure, refer to FIGURE 3.6 on page
Safety Inspection Checklists
SECTION 4-SAFETY INSPECTION/ TROUBLESHOOTING
Initially
Before Each Use
Cleaning the Door Seal Gasket
Cleaning
Cleaning Your Tub
Removing Soap Film and Hard Water Deposits
SECTION 4-SAFETY INSPECTION/TROUBLESHOOTING
Heavy Duty Cleaning Procedure
Calibrating the Disinfectant Flow Meter
NOTE For this procedure, refer to FIGURE 4.1 on page
NOTE Equipment needed Bucket or Pail, at least 1 Gallon
Graduated plastic bottle, at least 16 ounces Felt Tip Pen
12. Close the whirlpool inlet by pulling the inlet plug out
NOTE Liquid will be heard filling the interior plumbing of the tub
Burp Fitting Burp Fitting
Troubleshooting
Disinfectant Valve Injector Screw
Disinfectant Cabinet Door
MAINTENANCE PERSON
Maintenance Record
TYPE OF MAINTENANCE PERFORMED
DATE
Side Entry Whirlpool Tub
Canada
LIMITED WARRANTY