SECTION 9—ANTI-TIPPERS/WHEEL LOCKS

SECTION 9—ANTI-TIPPERS/WHEEL LOCKS

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.

Installing/Adjusting Anti-tippers

WARNING

Anti-tippers are specific to the different seat-to-floor heights. Refer to the chart in this section of the manual for correct usage and adjustment. If these requirements cannot be achieved, DO NOT use the wheelchair. Contact a qualified technician. If changing the seat-to-floor height, the correct anti-tippers MUST be used to maintain a 11/2 to 2 inch ground clearance.

If so equipped, anti-tippers MUST be attached at all times. Inasmuch as the anti-tippers are an option on this wheelchair (You may order with or without the anti-tippers), Invacare strongly recommends ordering the anti-tippers as a safeguard for the wheelchair user.

Anti-tippers MUST be fully engaged and release buttons fully protruding out of adjustment holes.

ALWAYS use anti-tippers. When outdoors on wet, soft ground or on gravel surfaces, anti tippers may not provide the same level of protection against tipover. Extra caution MUST be observed when traversing such surfaces.

Ensure both anti-tippers are adjusted to the same mounting hole.

NOTE: For this procedure, refer to FIGURE 9.1 on page 34 and FIGURE 9.2 on page 35.

Installing Anti-Tippers

NOTE: To ensure the correct model anti‐tipper is used refer to FIGURE 9.1. Measurements for anti‐tippers are approximate and are taken with extension tube in bottom hole position.

WHEEL-

SEAT-TO-FLOO

ANTI-TIPPER (MEASUREMENTS IN INCHES)

CHAIR

R HEIGHT IN

LENGTH

HEIGHT

MODEL

PART NO.

MODEL

INCHES

 

 

 

 

TRACER EX2

17½ to 19½

13½

1360

1058836

TRACER EX2

 

 

 

 

 

FF

21

12

9758

1086190

Anti-Tipper Height

 

 

Flat Surface

 

 

 

 

 

 

Bottom Position

 

 

 

 

 

Anti-Tipper Length

FIGURE 9.1 Installing/Adjusting Anti-tippers- Anti-Tipper Length

1.Press the release buttons and insert the anti‐tippers with the anti‐tipper wheels pointing toward the ground/floor into the wheelchair frame tubing as shown in FIGURE 9.2.

Tracer® EX2

34

Part No. 1110546

Page 34
Image 34
Invacare EX2 warranty ANTI-TIPPERS/WHEEL Locks, Installing/Adjusting Anti-tippers