SECTION
SECTION 1—GENERAL GUIDELINES
WARNING
This section contains important information for the safe operation and use of this product.
Stability - All Models
The size/position of the front casters, size/position of the rear wheels, use of anti‐tipper model, as well as the user condition directly relate to the stability of the wheelchair. Any change to one or any combination of the six may cause the wheelchair to decrease in stability. These adjustments MUST be performed by a qualified technician.
The various seat‐to‐floor heights require specific settings depending on rear wheel size, rear wheel position and front caster size/position. These adjustments MUST be performed by a qualified technician.
NOTE: When changes to the |
| CASTER POSITION |
| WHEEL POSITION |
| USER CONDITION |
left hand column occur, follow | CASTER SIZE | WHEEL SIZE |
| |||
across the chart and refer to the | ||||||
procedure that is checked () to | ||||||
maintain the proper stability, | ||||||
safety and handling of the | ||||||
wheelchair. | ||||||
| ||||||
|
|
|
|
|
|
|
CASTER SIZE | • | X | X | X | X | X |
|
|
|
|
|
|
|
CASTER POSITION | X | • | X | X | X | X |
|
|
|
|
|
|
|
WHEEL SIZE | X | X | • | X | X | X |
|
|
|
|
|
|
|
X | X | X | • | X | X | |
|
|
|
|
|
|
|
USER CONDITION | X | X | X | X | X | • |
|
|
|
|
|
|
|
Anti-Tippers
Anti‐tippers are specific to the different angles and/or seat‐to‐floor heights. Refer to the charts in Installing/Adjusting Anti‐tippers on page 34 for correct usage and adjustment. If these requirements cannot be achieved, DO NOT use the wheelchair. Contact a qualified technician. If changing the seat‐to‐floor height, the correct anti‐tippers MUST be used to maintain a 11/2 to 2 inch ground clearance.
Anti‐tippers MUST be attached at all times. Inasmuch as the anti‐tippers are an option for on this wheelchair (you may order with or without the anti‐tippers), Invacare strongly recommends ordering the anti‐tippers as a safeguard for the wheelchair user.
ALWAYS use anti‐tippers. When outdoors on wet, soft ground or on gravel surfaces, anti tippers may not provide the same level of protection against tipover. Extra caution MUST be observed when traversing such surfaces.
Operating Information
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely ‐ otherwise injury or damage may result.
Unless otherwise noted, all service and adjustment should be performed while the wheelchair is unoccupied.
Avoid storing or using the wheelchair near open flame or combustible products. Serious injury or damage to property may result.
ALWAYS keep hands and fingers clear of moving parts to avoid injury.
To determine and establish your particular safety limits, practice bending, reaching and transferring activities in several combinations in the presence of a qualified healthcare professional before attempting active use of the wheelchair.
Tracer® EX2 | 6 | Part No. 1110546 |
