SECTION
SECTION 11—OPTIONS
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.
Installing Amputee Bracket
NOTE: For this procedure, refer to FIGURE 11.1 on page 38.
1.Refer to the following chart or FIGURE 11.1 to determine the mounting position of the amputee bracket:
*BRACKET | AXLE SPACER POSITION | SIDE OF | AXLE MOUNTING | |
|
| (ON BRACKET) | WHEELCHAIR | POSITION |
|
|
|
| (ON WHEELCHAIR) |
|
|
|
|
|
ADULT | A | DOWN | RIGHT | TOP |
ADULT | B | DOWN | LEFT | TOP |
HEMI | B | UP | RIGHT | BOTTOM |
HEMI | A | UP | LEFT | BOTTOM |
|
|
|
|
|
*NOTE: ʺAʺ and ʺBʺ are stamped on the sides of the amputee bracket.
2.Install the amputee bracket on the wheelchair frame to the position determined in STEP 1. NOTE: Make sure the axle spacer is pointing towards the outside of the wheelchair.
3.Install the two hex screws and locknuts that secure the amputee bracket to the wheelchair.
4.Install the rear wheels onto the wheelchair. Refer to Removing/Installing Rear Wheels on page 30.
Bracket “A” | Bracket “B” |
Locknuts
Adult Right 
Axle Spacer Toward Outside
of Wheelchair
LeftRight
Adult Left
Axle Spacer Toward Outside
of Wheelchair
Rear View of
Amputee Bracket
Hex Screws 
Hemi Left | Hemi Right |
FIGURE 11.1 Installing Amputee Bracket
Tracer® EX2 | 38 | Part No. 1110546 |
