Invacare EX2 warranty Label Location, Important Notice

LABEL LOCATION

LABEL LOCATION

IMPORTANT NOTICE

The wheel locks on this wheelchair have been pre-set at the factory to comply with the Veterans Administration functional Standard 8320.01 of the Federal Register, paragraph

3.2.4.5.3.If these wheel locks do not meet your needs, follow instructions below.

!CAUTION

Any wheel lock adjustments should embed wheel lock shoe at least 1/8" into tire when locked (3/16" on pneumatic tires).

INSTRUCTIONS FOR WHEEL

LOCK ADJUSTMENTS

1.Loosen wheel lock mounting fastener, which runs through mounting bracket and frame.

2.Slide clamp toward rear wheel until wheel lock shoe is embedded into tire material at least 1/8" when handle is engaged to the lock position (3/16" for pneumatic tires).

3.Tighten mounting fastener to secure mounting bracket in desired location and recheck lock shoe embedding.

4.Inspect for correct locking action BEFORE actual use.

00078X021-0394

Crossmember

Lower Frame

Tube

NOTE: On all adjustable anti‐tippers

WARNING

Refer to Owner's Manual for proper anti-tipper

setting. 1085379

WARNING

DO NOT OPERATE WITHOUT

	THE ANTI-TIP TUBES
REV. 5/98	INSTALLED. P/N 60106X144

Tracer® EX2 4 Part No. 1110546