INSTALLATION
SECTION 2— INSTALLATION
Assembling the Base, Mast and Horn Assembly
WARNING
The mast may be removed from the base for storage or transporting. Each time the mast is removed and returned to the socket of the base, the mast MUST be locked into the socket of the base assembly.
NOTE: For this procedure, refer to FIGURE 2.1 and FIGURE 2.2 on page 12.
1.Unpack the components from the shipping cartons.
2.Remove the locking screw from the bottom of the base.
3.Match the notch at the bottom of the mast assembly with the tabs inside the socket of the base assembly.
4.Insert the mast assembly into the socket and onto the tabs.
5.Attempt to turn the mast assembly.
NOTE: If the mast does not turn, the mast is centered and locked in place.
6. Insert the locking screw into the bottom of the base and tighten securely.
Notch
Mast
Locking
ScrewSocket
Tab
FIGURE 2.1 Assembling Mast to Base
7.Remove the shoulder bolt, steel washers, nylon washers, and locknut from the horn mounting lugs at the top of the mast assembly.
8.Align the holes of the horn mounting lugs and the horn bushing.
9.Insert the shoulder bolt completely through the holes of the horn mounting lugs, horn bushing, nylon washers and steel washers. Refer to FIGURE 2.2 on page 12.
