MAINTENANCE
The connection between the mast and the base should be cleaned and coated with petroleum jelly prior to assembly.
Detecting Wear and Damage
It is important to inspect all stressed parts, such as slings, sling attachment knobs, and any pivot for slings for signs of cracking, fraying, deformation or deterioration. Replace any defective parts immediately and ensure that the lift is not used until repairs are made.
All sling metal parts should be inspected every three months and if wear is apparent, replacement must be made.
Check that all labels are present and legible. Replace if necessary.
Cleaning the Sling and the Lift
The sling should be washed regularly in water temperature of 180°F (82°C) and a biological solution. A soft cloth, dampened with water and a small amount of mild detergent, is all that is needed to clean the lift. The lift can be cleaned with non‐abrasive cleaners.
Replacing the Knee Pad
NOTE: For this procedure, refer to FIGURE 8.2.
1.Remove the four button screws and washers that secure existing knee pad to the lift.
2.Remove the existing knee pad from the lift.
3.Position the mounting holes in the new knee pad with the mounting holes in the lift.
4.Using the existing hardware, secure the new knee pad to the lift.
Knee Pad | Button Screw and |
| Washer (1 of 4) |
| Adjustment Pin |
| (1 of 2) |
