PROCEDURE 1 | FOOTREST |
|
|
F O O T R E S T
Footrest Support | SIDE VIEW |
Footplate | O F |
FOOTPLATE | |
| AND |
| FOOTREST |
| SUPPORT. |
FIGURE 5 - ADJUSTABLE ANGLE FLIP-UP
FOOTPLATE ANGLE ADJUSTMENT
Adjustable Angle
NOTE: It is not necessary to remove the footplate to perform this adjustment.
1.Insert a flathead screwdriver through the half clamp on the articulating footplate.
2.Slowly turn the nylon adjustment screw in or out until the articulating footplate is perpendicular to the footrest assembly or the desired inversion or eversion is obtained.
Calf Strap
Impact
Guards
FIGURE 7 - IMPACT GUARDS/OPTIONAL
CALF STRAP
REPLACING HEEL LOOPS (FIGURE 8)
Composite Footplates
1.Remove the hex screw and coved washer that se- cures the lower half of the footrest to the swingaway footrest assembly.
2.Remove the lower footrest assembly.
3.Remove the phillips screw and locknut that secure the heel loop to the footrest.
Footrest Support FRONT VIEW OF
FOOTPLATE AND
4. | Slide heel loop over slide tube of footrest assembly. |
5. | Replace heel loop. |
Footplate
FOOTREST SUPPORT.
COMPOSITE FOOTPLATES
Hex Screw/Coved Washer
Phillips Screw
Spacer
FIGURE 6 - ADJUSTABLE ANGLE FLIP-UP FOOTPLATE PERPENDICULAR AND/OR INVERSION/EVERSION ADJUSTMENT
IMPACT GUARDS/CALF STRAP (FIGURE 7)
NOTE: The following procedure is for all Pro Series Wheelchairs.
1.Remove impact guard/calf strap from packaged container if not already secured to the footrest.
2.Secure the impact guards to the footrest frame as shown in FIGURE 7.
3.Secure the optional calf strap around the footrest frame (with the impact guards attached).
Locknut
ADJUSTABLE FOOTPLATES
Phillips Screw
Washer
Washer 
Phillips Screw
FIGURE 8 - REPLACING HEEL LOOPS
1 6
