SECTION 10 | RECLINER |
REPLACING THE HEADREST PILLOW (FIGURE 2)
RECLINER
1.Unfasten straps of headrest pillow from behind headrest upholstery.
2.Remove existing headrest pillow from headrest.
3.Center new/existing headrest pillow onto the front of the headrest upholstery.
4.Pull straps of new/existing headrest pillow around the back canes.
Fastening | Headrest Upholstery | Strap |
Strips |
|
|
Strap
Headrest Pillow
5.Pressing firmly, attach the fastening strips
of the new/existing headrest pillow to the fastening strips on the back of the headrest upholstery.
REPLACING THE HEADREST/BACK UPHOLSTERY (FIGURE 3)
HEADREST UPHOLSTERY
1.Remove the headrest pillow. Refer to
REPLACING THE HEADREST PILLOW in this section of the manual.
2.Remove the six (6) mounting screws that secure the headrest upholstery to the headrest extension tubes.
3.Secure NEW headrest upholstery onto headrest extension tubes with the existing six (6) mounting screws.
4.Install headrest pillow. Refer to REPLAC- ING THE HEADREST PILLOW in this section of the manual.
BACK UPHOLSTERY
1.Disengage one (1) side of the spreader bar. Refer to REMOVING/INSTALLING THE SPREADER BAR in this section of the manual.
Headrest Upholstery | Mounting |
Headrest | Screws |
| |
Extension |
|
Tube | Back |
| |
| Upholstery |
Back | Mounting |
Cane | Screws |
FIGURE 3 - REPLACING THE
HEADREST/BACK UPHOLSTERY
NOTE: To remove and install the bottom two (2) mounting screws of the back upholstery the wheelchair must be partially folded. Refer to SAFETY/HANDLING OF WHEELCHAIRS in SECTION 1 of this manual
2.Remove the twelve (12) mounting screws that secure the back upholstery to the back canes.
3.Secure NEW back upholstery to back canes with the existing twelve (12) mounting screws. Securely tighten.
4.Reengage spreader bar. Refer to REMOVING/INSTALLING THE SPREADER BAR in this procedure of the manual.
Tracer® SX5 | 48 | Part No. 1110550 |
