OPTIONS

SECTION 11

Section 11 - Options includes the following:

Installing the Amputee Bracket

Installing the Crutch and Cane Carrier

Installing the Seat Positioning Strap

Installing the Telescoping I.V. Rod

NOTE: The procedures in this section of the manual refer to NON-RECLINER wheelchairs, EXCEPT INSTALLING THE SEAT POSITIONING STRAP.

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attach- ing hardware is tightened securely - otherwise injury or damage may occur.

INSTALLING THE AMPUTEE BRACKET (FIGURE 1)

1.Refer to the following chart or FIGURE 1 to determine the mounting position of the amputee bracket:

2.Install the amputee bracket on the wheelchair frame to the position determined in STEP 1. NOTE: Make sure the axle spacer is located to the outside of the wheelchair.

3.Install the two (2) hex screws and locknuts that secure the amputee bracket to the wheelchair.

4.Install the rear wheels onto the wheelchair. Refer to REMOVING/INSTALLING THE REAR WHEELS in SECTION 6 of this manual.

SEAT-

*BRACKET

AXLE SPACER

SIDE OF

AXLE MOUNTING

TO-FLOOR

 

POSITION

WHEELCHAIR

POSITION

 

 

(on bracket)

 

(on wheelchair)

ADULT

A

DOWN

RIGHT

TOP

ADULT

B

DOWN

LEFT

TOP

HEMI

B

UP

RIGHT

BOTTOM

HEMI

A

UP

LEFT

BOTTOM

*"A" and "B" are stamped on the sides of the amputee bracket.

BRACKET "A" BRACKET "B"

ADULT

RIGHT

Axle Spacer Towards OUTSIDE

of Wheelchair

LEFT RIGHT

Locknuts

ADULT

LEFT

Axle Spacer Towards OUTSIDE

of Wheelchair

REAR VIEW OF

AMPUTEE BRACKET

Hex Screws

HEMI LEFTHEMI RIGHT FIGURE 1 - INSTALLING THE AMPUTEE BRACKET

OPTIONS

Part No. 1110550

51

Tracer® SX5

Page 51
Image 51
Invacare SX5 Recliner manual Options Section, Adult Right, Adult Left, Rear View