SEAT BACKAND

SECTION 5

SEAT AND BACK

 

 

 

ADJUSTING SEAT DEPTH (FIGURE 4)

WARNING

The seat depth, size/position of the front casters, size/position of the rear wheels, use of an anti-tipper model, as well as the user condition directly relate to the stability of the wheelchair. Any change to one (1) or any combination of the seven (7) may cause the wheelchair to decrease in stability. These adjustments MUST be performed by a qualified techni- cian.

1.Remove the existing seat upholstery from the wheelchair. Refer to REPLACING SEAT UPHOLSTERY in this section of the manual.

NOTE: If adjusting the seat depth of the wheelchair, the seat upholstery MUST be changed as well.

2.Remove the two (2) plug buttons from the ends of the crossbraces that are towards the front of the wheelchair.

NOTE: The two (2) plug buttons will be used in the ends of the seat extensions.

3.Install the two (2) seat extension tubes into the ends on the crossbraces. Line up the rear mounting hole of the seat extension tube with the second mounting hole from the end of the crossbrace.

4.Install the two (2) seat extension spacers onto the two (2) seat extension tubes.

5.Install the new seat upholstery onto the wheelchair. Make sure to line up the mounting holes in the seat extension tubes and seat extension spacers with the new seat upholstery. Refer to REPLACING SEAT UPHOLSTERY in this section of the manual.

6.Install plug buttons into the ends of the seat extension spacers.

Phillips Screws

Seat Extension

Spacer

Seat Upholstery

Crossbrace

SECOND Mounting Hole From End

Plug Button

REAR Mounting Hole

 

 

Seat Extension Tube

FIGURE 4 - ADJUSTING SEAT DEPTH

Tracer® SX5

30

Part No. 1110550

Page 30
Image 30
Invacare SX5 Recliner manual Adjusting Seat Depth Figure