Invacare SX5 Recliner manual Footrest Height Adjustment Figure, Heel Loop Replacement Figure

FRONT RIGGINGS

SECTION 3FRONT RIGGINGS

FOOTREST HEIGHT ADJUSTMENT (FIGURE 2)

NOTE: This procedure applies to the swingaway		Upper Footrest Support
footrest and eleveating legrest.		Release Button
1. Remove the swingaway footrest
	Adjustment
assembly. Refer to INSTALLING/		Lower Footrest Assembly
	Holes

REMOVING THE SWINGAWAY
FOOTREST in this section of the	Cam Lock
manual.
	Lever
NOTE: Lay the assembly on a flat surface to
	NOTE: Swingaway footrest shown.
simplify this procedure.
	FIGURE 2 - SWINGAWAY
2. Pull the cam lock lever to UP (UN-
	FOOTREST HEIGHT
LOCKED) position.
	ADJUSTMENT

3.Push IN the release buttons and

reposition the lower footrest assembly to the desired height.

4.Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support.

5.Rotate cam lock lever DOWN to LOCKED position.

6.Repeat this procedure for the other footrest, if necessary.

7.Reinstall the swingaway footrest assembly. Refer to INSTALLING/REMOVING THE SWINGAWAY FOOTREST in this section of the manual.

HEEL LOOP REPLACEMENT (FIGURE 3)

1.	Pull the cam lock lever to UP (UN-	Mounting Screw
	LOCKED) position.		Cam Lock Lever
2.	Push IN the release buttons and re-	Spacer
	move the lower footrest assembly.		Heel Loop
3.	Remove the mounting screw, spacer		Slide Tube
	and locknut that secure the heel loop
	to the footrest.		Lower
4.	Remove EXISTING heel loop from	Locknut	Footrest
	slide tube.		Assembly
5.	Install NEW heel loop onto slide tube.		Footrest
		FIGURE 3 - HEEL LOOP
6.	Install the mounting screw, spacer and
			REPLACEMENT
	locknut to secure the heel loop to the

footrest. Tighten until the spacer is secure.

7.Insert the lower footrest assembly into the upper footrest assembly to desired height.

8.Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support.

9.Rotate cam lock lever DOWN to LOCKED position.

Tracer® SX5 24 Part No. 1110550