SECTION 9—WHEEL LOCKS

Push-to-Lock or Pull-to-Lock Wheel Locks

Under Mount Wheel Lock

Mounting Screws 3/16 inch (.47 cm)

Mounting Screws

3/16 inch (.47 cm)

(1/8-inch) (.32 cm)

 

(1/8-inch) (.32 cm)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Wheel

Tyre

Wheel

Wheel Lock

Wheel

Lock

Lock Shoe

Lock Shoe

Tyre

FIGURE 9.1 Replacing/Adjusting the Wheel Locks

Changing Wheel Lock Handle Position

NOTE: For this procedure, refer to FIGURE 9.2.

1.Loosen, but DO NOT remove, the rear handle mounting screw.

2.Remove the front handle mounting screw and locknut.

3.Align the front handle mounting hole with one of three desired mounting positions on the wheel lock.

4.Using the front handle mounting screw

and locknut, secure the handle to the wheel lock.

Wheel lock Handle

Mounting

Positions

5.Securely tighten the front and rear handle mounting screws and locknuts.

6.Repeat STEPS 1-5 on remaining wheel lock handle.

Rear Handle

Front Handle

Mounting

Mounting

Screw and

Screw

Locknut

 

FIGURE 9.2 Changing Wheel Lock Handle

Position

Crossfire™Series Wheelchairs

56

Part No 1148078

Page 56
Image 56
Invacare T6 manual Changing Wheel Lock Handle Position, Replacing/Adjusting the Wheel Locks