SECTION
Installing/Adjusting Optional Clamp on Raised Footrest
NOTE: For this procedure, refer to FIGURE 4.2.
Installing
1.Install the two half clamps onto either side of the wheelchair frame approximately
2.Repeat for the opposite side of the wheelchair.
3.Slide the clamp on raised footrest into the half clamps to the desired height.
4.Securely tighten the four allen screws.
Wheelchair Frame | Allen | |
| Screws | |
Half Clamp |
| |
Raised | Outside | |
Footrest | ||
Footrest | ||
Hoop | ||
|
FIGURE 4.2 Installing/Adjusting Optional
Clamp on Raised Footrest
Adjusting
1.Loosen the four allen screws.
2.Adjust clamp on raised footrest to the desired height.
3.Securely tighten the four allen screws.
Replacing/Adjusting Optional Adjustable Angle Footrest
NOTE: For this procedure, refer to FIGURE 4.3 on page 27.
Replacing the Footrest
1.Loosen, but DO NOT the allen screw of the two clamps that secure the footrest to the wheelchair frame.
2.Slide the existing footrest tubes out of the wheelchair frame and install new footrest by reversing this step.
3.Position the new footrest to a determined height.
4.Tighten the allen screw of the two clamps that secure the footrest to the wheelchair frame.
5.Adjust the footplate to the desired position. Refer to Adjusting Footplate Angle on page 27 and/or Adjusting Footplate Depth on page 27.
Crossfire™Series Wheelchairs | 26 | Part No 1148078 |
