SECTION 8—WHEELS

Adjusting the Camber Tube

WARNING

STANDARD and axle tube clamps - Make sure the hex screws are securely tight- ened before using the wheelchair, otherwise injury or damage to the wheelchair may occur.

NOTE: For this procedure, refer to FIGURE 8.12.

Stand behind the wheelchair to determine left or right.

1.Loosen, but DO NOT remove the four socket screws camber tube clamps.

2.Using an "L" square, rotate the axle tube until the flat edge of the camber tube is at a 90° angle with the ground/floor.

3.Securely tighten the four socket screws camber tube clamps.

4.Determine the toe in/toe out of the wheelchair. Refer to Adjusting Wheelbase Length (Adjusting Center of Gravity) on page 42.

Flat Edge of Camber Tube

(Place “L” Square Here)

“L” Square Here

(90° Angle)

Ground/

Floor

FIGURE 8.12 Adjusting the Camber Tube

Crossfire™Series Wheelchairs

48

Part No 1148078

Page 48
Image 48
Invacare T6 manual Adjusting the Camber Tube, Stand behind the wheelchair to determine left or right