SECTION 6—BACK

SECTION 6—BACK

WARNING

ALWAYS perform these procedures in the presence of an assistant. The position of the footrest, camber tube, back angle, the tautness of the back upholstery as well as the user's condition are directly related to the wheelchairs stability. Any change to one or any combination of the five may cause the wheelchair to decrease in stability. Use EXTREME caution when using a new seating position. The addition of anti-tippers may be required.

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.

Unfolding/Folding the Back

WARNING

Back MUST be locked securely in place before using the wheelchair.

NOTE: For this procedure, refer to FIGURE 6.1

1.To unfold the back, lift up on the back canes and pull back towards the rear of the wheelchair until it locks into place.

2.To fold the back, pull up on the back release cord and push the back canes forward toward the front of the wheelchair.

Rear of

Front of

Wheelchair

Wheelchair

Back Cane

NOTE: Back upholstery

removed for clarity.

Back Release Cord

(Not Shown)

FIGURE 6.1 Unfolding/Folding the Back

Back Angle Adjustment

NOTE: For this procedure, refer to FIGURE 6.2 on page 31.

NOTE: Perform this procedure on both sides of the wheelchair at the same time.

Crossfire™Series Wheelchairs

30

Part No 1148078

Page 30
Image 30
Invacare T6 manual Unfolding/Folding the Back, Back Angle Adjustment