Assembly
FIGURE 3:
Step 1:
Slide the Plastic Bellow (14) onto the Console Tube (2).
Step 2:
Connect the Console Cable (7) to Sensor Wire (36). Connect the Resistance Cable (73) to the Cable from the Console Tube (Figure
Step 3:
Using Six M8x18mm Washers (72) and M8x15mm Screws (63), Attach the Console Tube (2) to the Main Frame( 1). Slide the Plastic Bellows down until it meets the Main. Assembly. Secure using M4x16mm Screw (19)
Figure 3
FIGURE 3a: Connect the Tension Knob to the Resistance Cable. Fit the Resistance Control Cable into the slot of the Tension Knob. Pull the brass end of the Resistance Control Cable over the lip of the Tension Knob Bracket. The connection should look like Figure 3c when completed.
3a
3b
3c |
FIGURE 4
Step 1:
Pull the Hand Pulse Wires (25a) coming from the Front Handlebar (5) through the Console Tube. Attach Front Handlbar (5) to Console Tube using Two M8x45mm Screws (23), Three M8x19mm Washers (50), Two 8mm Acorn Nuts (13), and One M8x15mm Screw (63).
Figure 4
