Contents | Jameco Electronics Superpro Series guide

Contents

1.General Description

1.1Introduction

1.1.1What is Superpro?

1.1.2Manual Organization

1.1.3Manual Convention

1.1.4System Requirement

1.3.2Package

1.2System Setup

1.2.1Software Installation

1.2.2Hardware Installation

1.2.3Running the Program

1.2.4Communication Error message

1.2.5Device Insertion

1.3Programming Operation

1.3.2Quick Guide to Programming

1.3.3Error Messages

2.Description of Menus

2.1File: <Alt-F>

2.1.1Load

2.1.2Save

2.2Buffer: <Alt-B>

2.2.1Edit

2.2.2Encryption Table

2.2.3Vector Table

2.3Device: <Alt-D>

2.3.1Run

2.3.2EditAuto

Image 4

Jameco Electronics Superpro Series manual Contents

Contents

Page User’s Guide Copyrights Contents Customer Support Error Messages AppendicesTest Alt-T Option Alt-O Software include the following features Programming hardware include the following itemsGuide consists of three main parts Following conventions are used in this manual Minimum requirement is as follows Standard package contains the following Running the Program Adapters with 48 pins or less on SuperproIII Chips with more than 48 pins on SuperproIII File Alt-F Load Ctrl-O Buffer Alt-B SaveExit Edit Copy Swap Radix SearchNext Encryption Table Device Alt-D 1 Run Run Program Read Verify Blank CheckData Compare Auto Chip End Buff StartBuff End EditAuto Word Format Even Word ByteOdd Word Test Alt-T New Pattern Edit Pattern Delete Pattern Setting Options Alt-O4 TTL&CMOS test Auto Find Device Auto Increment model dependant Click Option Auto Increment Save config file Load config fileCustomer Support Xeltek Technical Support Error Messages Limited Warranty Invalid File Type