Jameco Electronics Superpro Series manual Buffer Alt-B, Save, Exit, Edit

Figure 8 Data type

2.1.2 Save

This selection will save the current data in the buffer to disk.

For E(E)PROM, BPROM or MCU device types, Save File window will pop up. Select the folder and filename to be saved under. Next, File Type dialog box will pop up for selecting file type to be saved under.

For PLD devices, the Save JED File dialogue box will pop-up to enter the file name.

2.1.3Exit

This command closes the programmer software and returns you to the control of the operating system.

2.2Buffer: <Alt-B>

The menu manages data in the buffer.

2.2.1 Edit

The selection brings up Fuse Buffer Edit window if the device type is a PLD, or Data Buffer Edit window for memory/MCU devices. The HEX/ASCII data buffer is 8 bit wide. Tab key may be used to switch between HEX and ASCII data for edit. You may edit the buffer data on the screen with the following keys:

<PageUp>	:Page up
<PageDown> :Page down
<Ctrl-PageUp>		:Move cursor to the beginning of the buffer
<Ctrl-PageDown>		:Move cursor to the end of the buffer
<Home>	:Move cursor to the beginning of the line

<End> :Move cursor to the end of the line