Running the Program | Jameco Electronics Superpro Series specs

switch and observe the power LED coming on bright. Please be sure not to insert any chip onto the programmer socket at this time.

1.2.3Running the Program

Please run the main program for the programmer. If everything is set up correctly, then the main screen should come up without any error message. At this point, you may select a device and proceed with programming operation.

Figure1. Main Screen

1.2.4Communication Error Message

Communication error may occur if the PC failed to communicate with the programmer. Please check the setup again and see to it that there is no device inserted in the programmer socket.

Sometimes, the error message occurs when the programmer hardware is defective. If the problem persists please contact factory for support.

Image 8

Jameco Electronics Superpro Series manual Running the Program

Contents

Page User’s Guide Copyrights Contents Customer Support Error Messages AppendicesTest Alt-T Option Alt-O Software include the following features Programming hardware include the following itemsGuide consists of three main parts Following conventions are used in this manual Minimum requirement is as follows Standard package contains the following Running the Program Adapters with 48 pins or less on SuperproIII Chips with more than 48 pins on SuperproIII File Alt-F Load Ctrl-O Buffer Alt-B SaveExit Edit Copy Swap Radix SearchNext Encryption Table Device Alt-D 1 Run Run Program Read Verify Blank CheckData Compare Auto Chip End Buff StartBuff End EditAuto Word Format Odd Word ByteEven Word Test Alt-T New Pattern Edit Pattern Delete Pattern Setting Options Alt-O4 TTL&CMOS test Auto Find Device Auto Increment model dependant Click Option Auto Increment Customer Support Load config fileSave config file Xeltek Technical Support Error Messages Limited Warranty Invalid File Type