Janome 10001 manual Button Sewing, Button sewing with a shank

Button Sewing		Auto
		T
Regular	Shank
A		B
3.5
	Adjust
	A	Z

1

2

3

Button sewing

When you press the Button Sewing key, the Button Sewing window will show.

The standard setting for Regular Button Sew- ing will be chosen and set automatically.

The Feed Dog will be automatically dropped. In the Button Sewing Mode, you may select the following;

A:The Regular Button Sewing

B:Button Sewing with a Shank

For your convenience, stitch width keys are displayed on the screen.

Press the key to widen the width.

Press the key to narrow the width. NOTE: Only the right needle drop position will

move when pressing or key.

Button sewing with a shank

1.Place a button on the fabric and lower the needle by turning the handwheel with your hand, so that the needle enters through the left hole on the button.

2.Align the direction of button and lower the Button Sewing Foot T to hold the button in place.

3.Press the Up/Down Needle Button to bring the needle up to the highest position. Adjust the stitch width, so that the zigzag width matches with the distance of holes on the button.

4.Insert the Button Shank Plate under the button. Press the Start/Stop Button to sew and the machine will stop automatically.

1Button Shank Plate

5.Cut the Needle Thread at the Beginning.

2Needle Thread at the Beginning

6.Pull the needle thread to pick Bobbin Thread up between the button and fabric.

3Bobbin Thread

7.Wind the threads in opposite directions around the thread shank a few times and tie them together.

110