Janome 10001 manual Sensor BH, Pull down BH Lever, Sensor buttonholes

Sensor BH				Auto
	Pull down BH Lever			R
SEN17	AUT18	19	20	21
22	23	24	25	26
27	28	29	30	31
				Adjust
			A	Z
1
				2
				1
2
3
				58

Sensor buttonholes

NOTES:

•Buttonholes 17 and 19 to 27 are sensor buttonholes.

•The size of a buttonhole is automatically set by placing a button in the rear of Automatic Buttonhole Foot R.

•The button holder of the foot takes a button size of 0.5 cm (3/16”) to 2.5 cm (1˝) in diameter.

•It is sometimes necessary to change buttonhole size to match certain heavy or specific materials and threads.

•Make a test buttonhole on an extra piece of the fabric to check your settings.

•Place the button on the fabric and mark the top and bottom to determine the position of the buttonhole on the fabric.

•Use interfacing on stretch fabrics.

To sew

1Press the Up/Down Needle Button to raise the needle. Attach the Automatic Buttonhole Foot R snapping the Pin into the Groove of the foot holder. Raise the Presser Foot.

1 Pin

2 Groove

2Pull the Button Holder to the back, and place the button in it. Push it together tightly on the button.

3 Button Holder

NOTE:

•If the button is extremely thick, make a test buttonhole on an extra piece of the fabric. If it is difficult to fit the button through the test buttonhole, you can lengthen the buttonhole by pulling the Button Holder back a little. The length of the buttonhole will be increased.