FRONT-PANEL CONTROL
1Main Power Switch
2 System Power Control
3 Power Indicator
4 Headphone Jack
5 Tone Mode
6 Speaker Selector
7 Surround Mode Group Selector
8 Surround Mode Selector
9 Tuning Selector ) ‹ Button
! Tuner Band Selector
1Main Power Switch: Press this button to apply power to the AVR580. When the switch is pressed in, the unit is placed in a Standby mode, as indicated by the red Power Indicator 3 in the center of the System Power Control
2. This button MUST be pressed in to operate the unit. To turn the unit off and prevent the use of the remote control, this switch should be pressed until it pops out from the front panel so that the word “OFF” may be read at the top of the switch.
NOTE: This switch is normally left in the “ON” position.
2System Power Control: When the Main Power Switch 1 is “ON,” press this button to turn on the AVR580; press
it again to turn the unit off. Note that the Power Indicator 3 in the center of the switch will turn orange when the unit is on.
3Power Indicator: This LED will be lit in red when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn orange.
@Set Button
# › Button
$ Preset Station Selector % Input Source Selector ^ Tuner Mode Selector & Optical 3 Digital Input * Coaxial 3 Digital Input ( Video 4 Video Input Jacks Ó Video 4 Audio Input Jacks Ô Bass Control
Balance Control
4Headphone Jack: This jack may be used to listen to the AVR580’s output through a pair of headphones. Be certain that the headphones have a standard 6.4mm (1/4") stereo phone plug. The main room speakers will automatically be turned off when the headphone jack is in use.
5Tone Mode: This button controls the tone control settings, enabling adjustment of the bass and treble boost/cut and bal- ance or the removal of the tone controls from the signal path. The first press of the button displays a TONE IN message in the Main Information Display ˜. If you wish to set the tone controls to “flat,” without any treble, bass or balance alter- ation, press the ‹ or › Selector Buttons )# so that TONE OUT appears in the Lower Display Line B.
6Speaker Selector: Press this button to begin the process of configuring the AVR580 for the type of speakers it is being used with. For information on configuring the speaker settings, see page 24.
ÒTreble Control
ÚChannel Adjust Selector Û Delay Adjust Selector Ù Digital Input Selector ı Volume Control
ˆ Input Indicators
˜ Main Information Display ¯ Remote Sensor Window ˘ Surround Mode Indicators
7Surround Mode Group Selector: Press this button to select the
Dolby Modes _ DTS Digital Modes _ VMAx Modes _ DSP Modes _ Stereo Modes _ Logic 7 Modes
Once the button is pressed so that the name of the desired surround mode group appears in the
8Surround Mode Selector: Press this button to select from among the available surround mode options for the major mode group selected. The specific modes will vary based on the number of speak- ers available, the major mode group and whether the input source is digital or ana- log. For example, press the Surround Mode Group Selector 7 to select a major mode grouping such as Dolby or
6
