5.Mount blower motor to the floor with 4 - #8 x ¾" hex head screws provided.
Top View
6.Go to the “Electrical Connection” section.
Floor Venting
1.Mark the floor at the center of the cabinet opening.
NOTE: If the template is misplaced, the following measurements can be used to determine the vent hole location.
Top View
| B | C |
|
| |
|
| D |
A | E | F |
| ||
|
| |
|
| G |
| I |
|
| H |
|
A. 9" (22.8 cm) | F. 12½" | (31.7 cm) | |
B. 3¹⁄₈" (7.9 cm) | G. 18¾" | (47.6 cm) | |
C. 8³⁄₈" (21.3 cm) | H. 1½" | (3.8 cm) | |
D. 6³⁄₈" (16.2 cm) | I. 3½" | (8.9 cm) |
E. 2¼" (5.7 cm)
4.Draw and cut a 6¼" (15.8 cm) diameter hole (option 1 shown).
2.Position template on floor by matching the centerline of the template to the centerline drawn on the floor and place template 2¼" (5.7 cm) from the back wall.
3.Determine the correct position for the vent hole, depending on obstructions (joists) in the floor.
The hole can be cut anywhere within the boundaries of either hatched area.
Option 1: If using the back hatched area (bigger one), the blower inlet must face the left side as shown on the template
Option 2: If using the front hatched area (smaller one), the blower inlet must face the back.
Top View
Option 1 | Option 2 |
A B
A. Option 1
B. Option 2
5.Position blower motor in cabinet opening and mount blower motor to the floor.
Top View
Option 1 | Option 2 |
B
B
A
A
B
A. Inlet from range
B. Exhaust outlet
A
A
B
A. Inlet from range
B. Exhaust outlet
11