8.Check that the
■Look for the anti-tip bracket securely attached to floor or wall.
■Slide range back so rear range foot is under
9.Level the range.
a.) Place rack in oven.
b.) Place level on rack and check levelness of the range, first side to side; then front to back.
c.) If range is not level, pull range forward until rear leveling leg is removed from the
d.) Use a wrench or pliers to adjust leveling legs up or down until range is level.
e.) Push range back into position.
f.) Check that rear leveling leg is engaged in
10.Depending on your installation, connect the flexible vent from the blower motor inlet to the range using a vent clamp.
Wall Venting
Top View
Floor Venting
Top View
B
A
C
A.Range
B.Floor venting outlet
C.Vent clamp
Side Venting (left side venting shown)
Connect flexible vent duct to range and connect vent system to blower motor outlet.
Top View
A
E
D
C
B
B | D. Vent system |
A. Flexible vent duct to range | |
B. Vent clamp | E. Side venting outlet |
C. Range |
|
11. Replace access panel. |
|
A |
|
C |
|
A. Range |
|
B. Wall venting outlet |
|
C. Vent clamp |
|
20