Other Hints on Caring for Your Oven
Cleaning Other Surfaces of Your Oven
Door and control panel trim: The metal trim around the door and the control panel
can be cleaned with any nonabrasive cleansers such as Ben Ami or soapy water, rinse well. Be careful not to use an excessive amount of water.
Glass on the oven door front: To clean, use any suitable glass cleaner or soapy water. To preventmoisture from getting behindthe glass control panel,spray acloth with
glass cleaner then wipe the panel.
Control Knob: Control knob can be removedfor cleaning. Wash inwarm soapywater. Match the "D" shaped hole in the knob to the "D" shaft when replacing.
Control Panel: Wipe with a damp cloth. Drythoroughly. Do not use cleaning sprays, large amounts of soap and water, abrasives, or sharp objects on the
Oven Racks | __' | _ |
To removepullforwardto the"stop" position; lift | ___)j_t_/_f |
|
up on the front of the rack and pull out. | _ ".......\ _/1_ | I I\ [_1 |
Oven Light Bulb
Before replacing bulb, disconnect powerto oven at the main fuse or circuit breakerpanel. Be sure that the entire oven cavity including the light bulb is cool before attempting to remove.
To replace light bulb:
1.Carefully remove the glass light lens and lens retainer by removing the two screws in the light lens retainer using a phillips screwdriver. Note: The light lens is separate from the
light lens retainer. The two pieces will drop down into your hands at the same time. Do NOT remove the remaining two
screws.
2. To obtain firm graspon bulb, wear protectiverubbergloves. Removebyturningbulbtothe left. Donot touch a hotoven light bulb with a damp cloth as bulb will break. NOTE: If the bulb does break and youwishto removeit,be certainpowersupply is disconnectedand wear protectivegloves. You may contact your
3.Replace bulb with a 40 watt
4. Place light lens inside of light lens retainer. Holding the light lens and lens retainer in place, insert the two screws into the
light lens retainer and tighten.
33
