Installing the Push-stick Storage, Blade | Jet Tools JBTS-10MJS

Installing the Push-stick Storage

Attach the metal push-stick storage bracket (Figure 13) into the provided slot (D, Fig. 14) on the right side of the body shell. The bracket will snap into place.

Storage

Rip fence and miter gauge

Storage brackets for the rip fence (B, Fig. 14) and miter gauge (C, Fig. 14) are located on the right side of the saw housing.

Note: Adjust the miter gauge to 45º-60º before putting away in storage.

Blade wrench

Insert the handle of the blade wrench (A, Fig. 14) into the slot located to the right side of the saw housing.

Blade

1.Loosen and remove the knob (A, Fig. 15) on the left side of the saw housing.

2.Place extra blades (B, Fig. 15) onto the bushing. Replace the knob and tighten.

Figure 13

D

Figure 14

Figure 15

16

Image 16

Jet Tools JBTS-10MJS operating instructions Installing the Push-stick Storage, Rip fence and miter gauge, Blade wrench

Contents

Benchtop Series Model No. JBTS-10MJS Walter Meier Manufacturing Inc Warranty and Service More Information Table of Contents Page Page Table Saw Safety Specifications Definitions and Terminology Electrical Grounding InstructionsVolt Operation Only Extension Cords Features Features Shipping Contents Hardware Hardware Stand AssemblyAttaching Saw to Stand Mounting the Saw to Work Surface Rear Table Extension Handwheel Handle Installing the BladeRemoving the Blade Blade Guard Assembly Splitter riving knife installation Figure Installing the Push-stick Storage StorageRip fence and miter gauge Blade wrench Adjustments Setting up the StandAdjusting the Table Insert Folding the Stand Aligning the Blade Guard Splitter 45 Positive Stop Adjustment Adjusting the Positive StopBlade Tilt Pointer Stop Additional Blade Adjustments Blade Parallel to the Miter Slot Adjusting the Miter Gauge Rip Fence Adjustment Rip Fence Indicator Rear Table Extension AdjustmentAdjusting the Locking Lever Table Extension Scale Pointer Operation Basic Saw Operations Cutting Operations USE the TWO AT the Same Time Ripping Small Pieces Bevel Crosscutting 0~45 Blade Level & 90 Miter Angle Using the Wood Facing on the Rip Fence Interfere with the cut if used on the left side grooveMitering 0~45 Miter Angle Dado CutsPage Blade Raising and Tilting Mechanism MaintenanceLubrication Push Stick Construction Trouble TroubleshootingProbable Cause Remedy Ordering Replacement Parts PartsTable Saw Index No Description Size Qty Index No. Part No Description Size Qty JBTS10MJS-49 JBTS10MJS-105 JBTS10MJS-162 JBTS10MJS-224 Table Saw Page Mobile Stand JBTS10MJS-658 Wiring Diagram