Jointer-Planer Assembly
Referring to Figure 7:
Fence
1.Attach jointer fence (A) to back of jointer outfeed table (F3) with two each socket head cap screws
(Z) and lock washers (MM). Tighten screws with 5mm hex wrench (provided).
Lock Knobs
The
2.Install jointer infeed table lock knobs (V, R).
Note: The shaft length of each lock knob (refer to Figure 3) are different. Be sure to install each in the correct location.
Extension Table
3.Attach the planer outfeed extension table (J) to the main planer table (F4) with three each socket head cap screws (AA) and flat washers (HH). Tighten screws with 5mm hex wrench.
Extension Table Adjustment
Two setscrews located underneath the extension table (J) are used to adjust the height position of the outer (protruding) edge, which must be slightly higher than the main planer table (F4) in order to minimize snipe (see Avoiding Snipe on page 21).
4.Using a 4mm hex wrench (provided), turn setscrews slightly clockwise to raise the table or counterclockwise to lower the table.
Lock Handle
Referring to Figure 8:
Attach planer table lock handle (U) and flat washer (T).
Cutterhead Guard
5.Install cutterhead guard (C) by securing the bracket (C1) to the side of the jointer infeed table (F5) with two each pan head machine screws (FF) and hex nuts (GG).
Important: It is extremely important that spring action causes the cutterguard (C) to retract against the fence (A), concealing the cutterhead (A1). If spring return tension is not enough, adjust the spring located on the cutterhead pivot shaft accordingly.
11
Figure 7
Figure 8
