Jet Tools JJP-10BTOS Jointer Controls and Adjustments, Infeed Table Height Adjustment

Jointer Controls and Adjustments

Refer to Figure 13.

Infeed Table Height Adjustment

Two lock knobs (F) and a height adjustment knob

(E)control the height adjustment of the infeed table

(D).

To adjust:

1.Loosen lock knobs (F).

2.Turn the height adjustment knob (E) clockwise to raise the infeed table (D) or counter-clockwise to lower the table.

The amount of table adjustment can be read on the scale (C).

3.Tighten the lock knobs (F).

Note: A depth of cut of 1/16" or less is recom- mended.

Cutterhead Guard

Properly positioned, the cutterhead guard (A) should rest against the fence (B1).

Fence Bevel Adjustment

The fence (B2) can be tilted backward (G) up to 45° (that is, for a total included angle of 135° from table surface) as follows:

1.Loosen lock handle (J).

2.Tilt the fence (B2) back to the desired angle up to 135 degrees (G). Or you can place your beveled reference piece on the table and against the fence, adjusting the fence until the angle of the fence matches the bevel of your gauge piece.

3.Tighten the lock handle (J).

Figure 13

14