Performance Troubleshooting – Planer
Trouble
Snipe
Note: Snipe can be minimized but not eliminated
Fuzzy Grain
Torn Grain
Rough/Raised Grain
Rounded, glossy surface
Uneven depth of cut side to side.
Board thickness does not match depth of cut scale.
“Chatter” marks on workpiece.
Probable Cause | Remedy | |
|
| |
|
| |
Inadequate support of long boards. | Support long boards with extension | |
| rollers. | |
|
| |
Dull knives. | Sharpen knives. | |
|
| |
Lumber not butted properly. | Butt end to end each piece of stock | |
| as they pass through. | |
|
| |
Planing wood with high moisture | Remove high moisture content from | |
content. | wood by drying. | |
|
| |
Dull knives. | Sharpen or replace. | |
|
| |
Too heavy a cut. | Adjust proper depth of cut | |
|
| |
Knives cutting against grain. | Cut along the grain. | |
|
| |
Dull knives. | Sharpen knives. | |
|
| |
Dull knives. | Sharpen knives. | |
|
| |
Too heavy a cut. | Adjust proper depth. | |
|
| |
Moisture content too high. | Remove high moisture content from | |
| wood by drying. | |
|
| |
Dull knives. | Sharpen or replace knives. | |
|
| |
Feed speed too slow. | Increase speed. | |
|
| |
Cutting depth too shallow. | Increase depth. | |
|
| |
Planer bed rough or dirty. | Clean pitch and residue, and wax | |
| planer table. | |
|
| |
Surface of feed rollers clogged. | Clear residue chips off of rollers. | |
|
| |
Knife incorrectly set. | Adjust knives. | |
|
| |
Depth of cut scale incorrect. | Adjust depth of cut scale. | |
|
| |
| Set knives properly as described in | |
Knives incorrectly set. | the Cutterhead Knife Adjustment on | |
page 15. Check that knife slots are | ||
| ||
| clean and free of dust or debris. | |
|
| |
Cutting too deeply. | Make shallower cuts. | |
|
|
24
