Figure 39 – Push Stick Template

Maintenance

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious personal injury.

Cleaning

Clean the JPS-10TS according to the schedule below to ensure maximum performance.

Note—The following maintenance schedule assumes the saw is being used every day.

Daily:

!Wipe down the table surface and grooves with a rust preventive.

!Clean the pitch and resin from the saw blade.

Weekly:

!Clean the motor housing with compressed air.

!Wipe down the fence rails with a dry silicon lubricant.

Lubrication

Lubricate the areas indicated below every 12 months.

!Lubricate blade angling trunnions with 6 or 7 drops of light machine oil.

!Lubricate the blade height trunnion with 6 or 7 drops of light machine oil.

!Worm gears and threads should be lubricated with an automotive wheel bearing grease.

Check all adjustments after lubricating.

Miscellaneous

Always be aware of the condition of your machine. Routinely check the condition of the following items and repair or replace as necessary:

!Mounting bolts

!Power switch

!Saw blade

!Blade guard

23

Page 23
Image 23
Jet Tools JPS-10TS operating instructions Maintenance, Cleaning, Lubrication, Miscellaneous